[OpenWrt-Users] Question for configuring OVS on OpenWRT

[Nam Bong Ha]

Hi, all

I am using an OpenWRT device that is configured to use ovs.

I want to communicate between wireless devices and wired devices.
Is the following connection possible?


ONOS
l
l
l
l
Device1(lan)---------(lan)OpenWRT-OVS(wireless)-------(wireless)Device2




I tried connecting the controller to OpenWRT (ovs).
However, ssh connection was disconnected at the moment of connection.

***@Controller$ ssh root@[OpenWRT IP]
***@OpenWrt:~# ovs-vsctl show
0ca359f7-74f-420f-b0a5-dfbb6f79
Bridge br-lan
Port "eth0.1"
Interface "eth0.1"
Port br-lan
Interface br-lan
type: internal
***@OpenWrt:~# ovs-vsctl set-controller br-lan tcp:[ONOS IP]:6633


The following is the configuration file for openwrt.

/etc/config/wireless
config wifi-device 'radio0'
option type 'mac80211'
option macaddr ':ae:99'
list ht_capab 'LDPC'
list ht_capab 'SHORT-GI-20'
list ht_capab 'SHORT-GI-40'
list ht_capab 'TX-STBC'
list ht_capab 'RX-STBC1'
list ht_capab 'DSSS_CCK-40'
option disabled '0'
option country 'KR'
option hwmode '11ng'
option htmode 'HT20'
option txpower '11'
option channel '1'

config wifi-iface
option device 'radio0'
option mode 'ap'
option ssid 'OpenWrt'
option encryption 'none'


/etc/config/network
config interface 'loopback'
option ifname 'lo'
option proto 'static'
option ipaddr '127.0.0.1'
option netmask '255.0.0.0'

config interface 'lan'
option type 'bridge'
option proto 'static'
option netmask '255.255.255.0'
option _orig_ifname 'eth0.1 radio0.network1'
option _orig_bridge 'true'
option ipaddr '192.168.30.1'
option ifname 'eth0.1 tap0 wlan0'

config interface 'wan'
option ifname 'eth0.2'
option _orig_ifname 'eth0.2'
option _orig_bridge 'false'
option proto 'static'
option ipaddr '192.168.0.230'
option netmask '255.255.254.0'
option gateway '192.168.0.1'

config switch
option name 'switch0'
option reset '1'
option enable_vlan '1'
option enable_learning '0'

config switch_vlan
option device 'switch0'
option vlan '1'
option ports '0t 2 3 4 5'
option vid '1'

config switch_vlan
option device 'switch0'
option vlan '2'
option ports '0t 1'
option vid '2'

Thank you:)
Have a good day :)